[Frameworks] Eumig S8 Projector Help for show starting in 3 hours!!!!

[jeanne LIOTTA]

oh dear. i believe you jason but I travelled several times through various
countries with Eumig 610 D and all  I had to do is switch the voltage as
Andrew has done and no problems with the lamp at all--always thought thats
the beauty of Eumigs, no big converters needed
???!

On Sat, Mar 5, 2011 at 9:17 AM, andrew lampert <andrewlampert at yahoo.com>wrote:

> Hi,
>
> I'm in Leipzig where there are technical dilemmas afoot and am wondering if
> anyone here has a hypothesis or better yet a solution. I have brought a
> Eumig 624D dual 8mm projector with me from the US for a show starting in a
> little bit. I went into the back of the projector where you can convert
> voltage from Us to European. I set it to 50hz and the setting that say
> "220-200, 230". We plugged it in and the motor starts however the bulb does
> not light. I put in a spare bulb and had the same issue. I used this
> projector just last week then tested it again before leaving and there was
> no problem. I am wondering if this has something to do with electricity or
> if there is some other reason. I don't (yet) believe that the projector is
> broken, there is hopefully an answer. Anyone have experience, electrical
> knowledge or insight to share? Please help if so!!!!
>
> THANK YOU,
> A.
>
>
> _______________________________________________
> FrameWorks mailing list
> FrameWorks at jonasmekasfilms.com
> http://mailman-mail5.webfaction.com/listinfo/frameworks
>
>


-- 
www.jeanneliotta.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman-mail5.webfaction.com/pipermail/frameworks/attachments/20110305/8962ab3d/attachment.html