[Frameworks] Tri x reversal super 8

[Jeff Kreines]

Hold the meter in the same light that strikes your subject, and point the dome back at the camera lens. That’s how you use an incident meter. Don’t use the slide unless you know what it does. 

Use 1/50th of a second for most cameras at 24 FPS unless you have to compensate for the camera’s prism. 

Compare to the camera’s light reading.  Are they in the ballpark?

If you can, shoot a test in 1/2 stop increments from 2.5 stops under to 2.5 stops over. That will help you figure out if your meter is accurate and if you are using it properly. 

Good luck!

Jeff Kreines
Kinetta
jeff at kinetta.com
kinetta.com

Sent from iPhone. 

> On Jul 24, 2019, at 2:50 PM, Ned Kihn <edward.kihn at gmail.com> wrote:
> 
> 
>> On Wed, Jul 24, 2019, 4:04 AM FrameWorks Admin <frameworks at re-voir.com> wrote:
>> Hi Shumona,
>> 
>> Actually the ASA depends on how you develop it. You can also push or pull by choosing your own ASA setting.
>> If you develop as negative, the ASA is usually rated at 400, and as reversal at 200, in daylight.
>> 
>> -Pip
>> 
>> 
>> 
>>>> On Jul 24, 2019, at 7:43 AM, Shumona Goel <shumonagoel at gmail.com> wrote:
>>>> 
>>>>  Dear Frameworks, 
>>> 
>>> I am shooting on super 8 tri x reversal black and white, stock number 7266. 
>>> 
>>> Do i rate this in daylight at 200 Asa? 
>>> 
>>> If i rate it at 200 Asa, do I need to open up any further than what the light meter indicates? I am using a sekonic analog meter. 
>> 
>> _______________________________________________
>> FrameWorks mailing list
>> FrameWorks at jonasmekasfilms.com
>> https://mailman-mail5.webfaction.com/listinfo/frameworks
> _______________________________________________
> FrameWorks mailing list
> FrameWorks at jonasmekasfilms.com
> https://mailman-mail5.webfaction.com/listinfo/frameworks
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman-mail5.webfaction.com/pipermail/frameworks/attachments/20190724/678f113b/attachment.html>