[Frameworks] Fuse holder for ST928 Steenbeck

[Scott Dorsey]

The original fuse holder is made by Schurter, and what you show here is just
the carriage.  The contacts on the part that is in the machine are bad,
which is why the contacts on the carriage are failing.

You have to replace the entire fuse holder assembly, not just the carriage.
My inclination is just to put a piece of sheet metal over the hole and
install a modern panel mount fuse holder that takes a 5/8 round hole.
It should be less than an hour for a competent technician.  This would be
much easier than trying to locate a US source for one that is the same
physical shape.

It is POSSIBLE that this is the same form factor as the model 348070/
348007 pair from Electronic Plus, as seen here:
http://www.electronicplus.com/content/ProductPage.asp?maincat=fus&subcat=fho

And that might work if your goal is to avoid doing any sheet metal work.
--scott